Quick answer
Build a loop around the central green creature rather than clearing its support immediately. The smaller creatures on the lower curve also need to be included before the ball finishes inside the loop.
- Level
- Level 10
- Difficulty
- Normal
- Objective
- Guide the red character to the green creatures in level 10, keeping each separated pocket reachable before the last drop.
Video walkthrough
Video by Go Answer on YouTubeWatch on YouTube
YouTube loads only when you press play. You can also open the video on YouTube.
Step-by-step
Round the bottom of the turn instead of leaving a sharp corner. A smooth floor helps the ball follow the bend.
Preserve the outer sand edge as a guide rail. Widen the inside of the turn only if the ball cannot fit through.
Check each branch for creatures before opening the final drop. A direct shortcut can leave a side pocket permanently out of reach.
Guide the ball through the remaining creature pockets. Check the edges of the cleared route before assuming that the board is finished.
Keep a shallow outer wall around the bend. It gives the red character a surface to follow instead of allowing a free fall past the pocket. Check the full target route after the last movement, including pockets above the final drop. If a creature remains, identify the earliest turn that missed it and change that local approach on the next attempt.
Tips
- Keep a shallow outer wall around the bend. It gives the red character a surface to follow instead of allowing a free fall past the pocket.
- Prepare the destination before opening the starting support. Keeping the first movement controlled makes it easier to tell whether a later failure comes from the tunnel shape or release order.
- Check the side branch before opening the lowest outlet. Once the character drops below a pocket, a later cut may no longer bring it back upward.
Common mistakes
- Opening the final outlet before checking higher target pockets can leave a creature above the character with no route back. Inspect the side entrances before making that irreversible drop.
- Removing several supports in one swipe makes the release order unpredictable. When a moving piece occupies the route, wait for it to settle before changing nearby sand.
Frequently asked questions
How do I keep the character in the curved passage?
Build a loop around the central green creature rather than clearing its support immediately. The smaller creatures on the lower curve also need to be included before the ball finishes inside the loop. An abrupt corner can redirect the character away from the next pocket. Keep the bend connected to its receiving floor; when the first attempt misses, adjust the approach angle rather than deepening the entire chamber.
Why should I keep the starting support?
Prepare the destination before opening the starting support. Keeping the first movement controlled makes it easier to tell whether a later failure comes from the tunnel shape or release order.
Which side pocket must I check before the final drop?
Check the side branch before opening the lowest outlet. Once the character drops below a pocket, a later cut may no longer bring it back upward.