Quick answer
Take the sloping route down the left of the tilted square block. Keep the bend below the block connected to the lower creature pocket instead of dropping straight onto the obstacle.
- Level
- Level 2
- Difficulty
- Normal
- Objective
- Guide the red character to the green creatures in level 2, keeping each separated pocket reachable before the last drop.
Video walkthrough
Video by Go Answer on YouTubeWatch on YouTube
YouTube loads only when you press play. You can also open the video on YouTube.
Step-by-step
Locate the red ball and every green creature before cutting. Keep the starting support until the route below is ready.
Extend the descending route along the left side of the solid obstacle. Leave a little sand as an outside retaining wall.
Keep an unbroken descending slope on the approach. A flat shelf or upward step can remove the momentum needed for the next turn.
Guide the ball through the remaining creature pockets. Check the edges of the cleared route before assuming that the board is finished.
Keep the landing slope continuous. Small upward steps near the exit can stop the character even when the preceding descent provided enough speed. Check the full target route after the last movement, including pockets above the final drop. If a creature remains, identify the earliest turn that missed it and change that local approach on the next attempt.
Tips
- Keep the landing slope continuous. Small upward steps near the exit can stop the character even when the preceding descent provided enough speed.
- Count the separated pockets rather than following only the lowest creature. The target furthest from the main chute may need a short detour before the final drop.
- Prepare the destination before opening the starting support. Keeping the first movement controlled makes it easier to tell whether a later failure comes from the tunnel shape or release order.
Common mistakes
- Opening the final outlet before checking higher target pockets can leave a creature above the character with no route back. Inspect the side entrances before making that irreversible drop.
- Removing several supports in one swipe makes the release order unpredictable. When a moving piece occupies the route, wait for it to settle before changing nearby sand.
Frequently asked questions
Why can the landing slope stop the character?
Take the sloping route down the left of the tilted square block. Keep the bend below the block connected to the lower creature pocket instead of dropping straight onto the obstacle. Keep the landing slope continuous. Small upward steps near the exit can stop the character even when the preceding descent provided enough speed.
How can I avoid leaving a green creature behind?
Count the separated pockets rather than following only the lowest creature. The target furthest from the main chute may need a short detour before the final drop.
Why should I keep the starting support?
Prepare the destination before opening the starting support. Keeping the first movement controlled makes it easier to tell whether a later failure comes from the tunnel shape or release order.